Milk Bar™ XL 4

Product Code: 910180

At 36L, the large capacity of 9L per teat and extra wide teat spacing of 19 cm makes the Milk Bar 4 super versatile and ideal for high volume systems, longer milk feeding systems and large breeds.
Like all Milk Bar feeders, the teats are positioned low in the milk channel to reduce waste.
Finger grips make handling easy and the feeder interstacks with teats fitted so you can carry as many as you like at once.
The Ezi Lock hooks lock onto any rail type up to 75mm so you can hang this lovely little feeder where ever you like!
Fitted with Milk Bar Teats to improve average daily gain.

With Ezi Lock Hooks you can hang this feeder on anything from wooden rails to hutch gates.
Simply hang the feeder in place, lock the hooks and fill with milk.
After feeding you can either remove the feeder, or flip it upside down until the next feed.

To give your calves the best drinking position, hang the feeder on a rail around
100 cm high. This puts the teat at 60cm which is the optimum height for calves and helps the oesophageal groove to close and milk to bypass the rumen.

How do I change my teats?


Milk Bar Teats have a pull through design to sit snugly against the feeder wall for optimum hygiene. However, while this is the most hygienic system, it can also be difficult to change teats!
Use a Teat Tool: This is by far the easiest method. The purpose designed Teat Tool plucks the teat from the feeder with minimal effort in seconds.
Pull the teats out by hand: When removing by hand, make sure to either pull the teat directly down or up. If you try to pull the teat straight out, it will be a tough job!
Cut the teats out: Make sure the blade is sharp and you use the knife away from you.

Be sure to check the teat alignment is correct and the slit is vertical!

Milk is a difficult substance to clean off of surfaces. You need hot water to remove the fat, but the heat can bake the protein onto the surface. Using warm water to get rid of the protein leaves a film of fat. When fats and proteins stick to the surface of equipment, they form a biofilm, a nutrient-rich layer in which bacteria grow.
The biofilm protects bacteria from the cleaning process and results in equipment that appears clean but has bacteria on the surface. The cleaning process not only needs to remove fat and protein from surfaces but prevent the formation of a biofilm.
All Milk Bar Teats are made from a natural rubber, much the same as your milking liners. Natural rubber absorbs the milk fat and protein which causes the teats to become softer.
Using an Alkali Detergent a few times a week with strip the milk fat and protein from the rubber so your calves can enjoy the controlled flow for longer.

  1. Rinse your feeder with water.
  2. Use an alkali detergent, following the manufacturers instructions.
  3. Using a brush to lightly scrub the feeder and outside of the teats making sure to bend the teats over.
  4. Rinse clean.
0:00 / 0:00

The Milk Bar 4 comes with teats and hooks fitted and ready to use.

Volume: 36L
Weight: 3kg
Length: 700mm
Height: 400mm
Width: 300mm

Warranty: The feeder has a two year warranty with proof of purchase.
The warranty does not apply to consumable parts (teats and hooks).

Made from food grade polyethylene and U.V Stabilised for long life.
Milk Bar Teats are made from a natural rubber with no synthetic or oil based additives.
NZ Pat Apps 757655 & 767633 & 727000. NZ Des Reg. 420972 PCT Patent Applications NZ2016/050190 & NZ2020/050110 International Patents and Designs pending or apply.
NZ Pat 518590 NZ Des Reg. 420972
NZ Pat 247112

Download Page

Related Products